Kichler Rana 310155 Manuel D'instructions page 10

9
Light kit
fitter assembly
screw
Fig. 20
Fig. 21
Fig. 22
11. INSTALLING THE LIGHT KIT
Step 1. Remove one screw from the light kit pan, and
loosen, but do not remove the other two screws. (Fig. 20)
Step 2. Connect the blue wire exiting the bottom of fan
motor assembly with the black wire from the top of the
light kit fitter assembly. (Fig. 20)
Step 3. Connect the white wire exiting the bottom of fan
motor assembly with the white wire from the top of the
light kit fitter assembly. (Fig. 20)
Step 4. Push the light kit fitter assembly up to the light
kit pan so that the two loosened screw heads fit into the
keyholes slots. Turn the light kit fitter assembly clockwise
to secure. (Fig. 20)
Step 5. Re-install the screw that was removed in step 1.
(Fig. 20)
NOTE:
tightened.
12. INSTALLING THE SHADE
Place the glass shade into the light kit pan, aligning the
Glass shade
three flat areas on the top flange of the shade with the
three raised dimples in the light kit pan. Turn the shade
clockwise until it stops. (Fig. 21)
NOTE:
the light kit. Allow the shade to cool completely before
removing.
If you install your fan without the light kit, do not install the
light kit fitter assembly and follow step below.
Place the non-light cap into the light kit pan, aligning the
three flat areas on the top flange of the non-light cap with
the three raised dimples in the light kit pan. Turn the non-
Non-light cap
light shade clockwise until it stops. (Fig.22)
FITTER ASSEMBLY
Make sure the mounting screws are securely
Do not overtighten when installing the shade into