Before Starting - KREA Swiss multiSPRAY Mode D'emploi

GETTING STARTED - tips & tricks
BEFORE STARTING: please ensure that the container is at least 50% full.
Do not use the multiSPRAY gun without material or spray until completely empty. This
avoids creating unnecessary noise & vibration and prevents splatter.
Always use clean material that is free of particles.
The multiSPRAY gun is designed to spray only pure fluids. Please avoid materials
containing seeds or any type of particles as they may restrict piston movement and
shorten the sprayer`s life. In case of doubts regarding any particles, filtering of the
material is recommended.
Optimum spraying
The power setting and piston size of the multiSPRAY allow it to deliver up to 250
grams of water per minute, with a maximum possible viscosity of up to 80 DIN/sec.
This is sufficient to lightly coat circa 7 - 12 m² using a surface pattern of about 10 cm,
sprayed at approximately 30 cm distance.
• Before starting, turn the power knob completely to the left (picture a, page 2).
This is the maximum power setting and after a few seconds will create sufficient
suction to spray the material. Adjust the power knob as required until the sprayer
demonstrates a fine spray and makes an even tone (picture b).
• Maintain a constant distance and smooth movement.
• Avoid shaking the gun or sharp movements as this will cause droplets.
• Varying the speed of arm movement, the height and number of coatings will vary
the effect and thickness of sprayed material.
• It is recommended to start and stop the sideways movement off the product and
only press the power button when over the product. This helps reduce the volume
being sprayer at the turning point.
• The supplied R6 round nozzle is the most suitable "all round" nozzle. Generally
using a smaller (R4) or larger (R8) holed nozzle can improve the results for thinner
or thicker materials, respectively.
• If you want to spray upwards i.e. from below, you may rotate the nozzle extension
- however - only rotate in a clockwise direction (when viewed from the front),
otherwise you will loosen the nozzle extension. The easiest method of adjusting the
nozzle direction is from the right side; hold the pump housing firmly with your left
hand and move the nozzle extension with your right hand.
5