Installation; Safety Instructions; Setup - ETNA VW844M Manuel D'utilisation

Installation

*
Door length
It is important that you read through and follow the instructions and directions below. Conduct
installation and connection in accordance with the separate installation instructions.

Safety instructions

Connections to electricity, water and drainage must be performed by a qualified professional.
Always follow applicable regulations for water, drainage and electricity.
Take care during installation! Wear protective gloves! There must always be two people!
Place a drip tray on the floor beneath the dishwasher to prevent damage from any water leaks.
Before screwing the dishwasher into place, test the dishwasher by running the One hour program
program with the SpeedWash option. Check that the dishwasher fills with water and drains. Check
also that none of the connections leak.
WARNING!
Turn off the water supply when installing the dishwasher!
The plug must be disconnected or power to the socket turned off while the work is carried out!

Setup

The recess and connection dimensions are included in the separate installation instructions. Check
that all dimensions are correct before starting the installation. Note that the height of the cover
door can be adjusted to match other fittings.
Make sure the area on which the dishwasher is to be installed is firm. Adjust the adjustable feet
so that the dishwasher is level.
If the dishwasher is built-in the surrounding furnishings must be resistant to any condensation
from the dishwasher.
Nominal dimensions. Actual measurements may vary.
[mm]
31