Cleaning & Maintenance; Troubleshooting - Inventum VR1420 Mode D'emploi

Congélateur
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6
cleaning & maintenance
Defrost the freezer compartment when the layer of ice reaches a thickness of 3 to 5 mm. It is recommended to combine
defrosting the appliance with cleaning it.
• Unplug the appliance.
• Open the door and remove the food from the freezer. Keep the contents of the freezer in a cool place and wrapped in blankets
or newspapers.
• Leave the door open, this will speed up the defrost process.
• Place a container under the freezing compartment and wait for the ice to defrost. You can speed up the defrosting process by
placing a bowl of hot water in the freezer.
Remove the ice with a plastic ice scraper.
Warning: Never remove the ice with the aid of sharp objects, defrost sprays, a hair-drier, a heater, or similar items. This may
lead to unsafe situations and may cause irreparable damage to the appliance.
• Clean the interior of the appliance. Use warm water and a neutral detergent to prevent any bad smells occurring. After cleaning,
rinse the interior with clean water and rub dry.
• Leave the appliance to dry for 1 to 2 hours. Simply remove the drawers to clean them by hand. Do not clean the interior
accessories in the dishwasher.
• Clean the outside of the appliance and the gasket with a soft moist cloth.
• Switch the thermostat on to the right setting. When the freezer compartment reaches its correct temperature, replace the
food items.
For areas that are difficult to clean in the appliance, such as narrow gaps or corners, it is recommended to wipe them regularly with
a soft rag, soft brush, etc. When necessary use some auxiliary tools, such as thin sticks (tooth picks), to ensure no contamination
can accumulate in these areas.
We recommend that you dust the back of the appliance and on the floor with a cloth or vacuum cleaner once a year in order to
maintain a good output and low energy consumption.
Do not use hard brushes, cleaning steel wire balls, wire brushes, abrasives, such as toothpastes, organic solvents (such as alcohol,
acetone, oils, etc.), boiling water, acid or alkaline items to clean the refrigerator considering that this may damage the fridge
surface and interior. Boiling water and benzene may deform or damage plastic parts.
NOTES
• Excessive accumulation of ice on the freezing areas impairs the appliance's freezing capacity and increases the energy
consumption.
• Defrost the appliance at least once or twice a year. In case of a higher ice build-up, defrosting must be carried out more
frequently.
• After taking the food out of the freezer, put it in a container, wrap it with several layers of paper, a blanket and store it at a cool
place.
• The defrosting operation should last as short as possible. Long storage of food at the ambient temperature shortens their shelf
life.
7

troubleshooting

Problem
Appliance is not functioning;
light does not work
Temperature inside the
freezer is too high or too low
Appliance is excessively noisy
Note: gurgling and hissing noises due to expansion in the refrigerant circuit are normal.
26
English
Cause
Appliance is not plugged in
Thermostat has been set incorrectly
Air circulation vents are blocked
Has the appliance been installed correctly?
Are the pipes at the back touching or vibrating?
Solution
Plug the appliance in the socket
Set the thermostat correctly
Clean the ventilation openings
Check the installation
Check it and move the appliance
forwards

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

875914

Table des Matières