Oceanic MF-40TC Guide D'utilisation page 29

b. Fan assembly
Loosen the nut (4) counterclockwise of
the motor (7). Mount the rear grille (5)
firmly on the motor, making the 3
mounting pads coincide. Tighten the nut
(4) clockwise on the grille to lock the
grille on the motor.
Fit the fan blades (3) on the shaft (6).
Fasten them firmly with the counter-
clockwise nut (2) counterclockwise.
The blades must be able to turn freely
without touching the clamping nut on the
rear grille.
Place the front grille on the rear grille,
attach the clips (Fig. 4) and tighten the
screw and clips (Fig. 5).
Pass the mist pipe through
the middle of the 2 support
tubes (1.).
Then pull the hose up past
the control panel. Bring the
mist hose out through the
hole above the control
panel (2.).
29