Philips NIVEA HS8420/40 Mode D'emploi page 9

30
sec
C F
- Do not exert too much pressure on the shaver, as
this may cause skin irritation.
- To ensure proper gliding, apply shaving conditioner
regularly.
- You can also use the shaver in the bath or shower.
Cleaning
Clean the shaver after every use.
Never use scouring pads, abrasive cleaning agents
or aggressive liquids such as alcohol, petrol or
acetone to clean the appliance.
Be careful with hot water. Always check if the
water is not too hot, to avoid burning your hands.
Never dry the shaving unit with a towel or tissue,
as this may damage the shaving heads.
1 Press the on/off button to switch on the shaver.
Note: Clean the shaver while it is switched on.
2 Immerse the shaving unit in hot water for at
least 30 seconds.
3 Switch off the shaver and shake off excess
water.
4 Slide the protection cap onto the shaver to
prevent damage.
Note: If the shaver does not shave as well as it used
to and you are unable to solve this with the cleaning
method described in this chapter, consult chapter
'Troubleshooting' for an extra-thorough cleaning
method.
EngliSH
11