Changing The Battery - Transistor Lynx TX-1 Manuel

ENGLISH
Fitting Lynx TX-1
Screws are supplied in the package which are used to fit Lynx TX-1 onto the wall.
Lynx TX-1 can also be attached using the Velcro tape supplied. If Lynx TX-1 is used
at different locations in the house and you want to be able to move it rapidly, Velcro
tape can be attached at different locations.
When the sound source is activated
When the sound source is activated, a wireless signal is sent to the receiver installed in
the Lynx system. The alert is given by vibration and symbols, loud noise or flashing
light, depending on the type of receiver.
Read the user manual for the receiver installed!
Flat battery
Lynx TX-1 is powered by a battery with a normal service life of approximately 5-10
years. When battery power begins to fail, Lynx TX-1 will send out an alert. It sends a
flat-battery warning along with the alarm to the receiver in the alerting system.
Read the user manual for the receiver installed!

Changing the battery

1. Open the blue cover. 2. Change the battery.
5