Introduction - Hayward Aqua Trol AQ-TROL-RJLS-CUL Manuel Du Propriétaire

Introduction

The Aqua Trol is an automatic chlorine generation system for above ground pools. The operation
®
requires a low concentration of salt (sodium chloride) in the pool water at levels low enough that it
normally will not be tasted. The Aqua Trol automatically sanitizes your pool by converting the salt into
free chlorine which kills bacteria and algae in the pool through a process called electrolysis. Because
chlorine will revert back to sodium chloride after killing the bacteria, these reactions will continuously
recycle virtually eliminating the need to add sanitizing chemicals to your pool. The only time you
may need to add more salt to the pool is when water is replenished due to backwashing, draining,
or splashing (not evaporation).
The Aqua Trol is designed to handle the purification needs of the average residential above ground
swimming pool of up to 18,000 gallons (67,500 liters). The actual amount of chlorination required
to properly sanitize a pool varies depending upon bather load, rainfall, temperature, and the pool's
cleanliness.
NOTE: Before installing this product as part of a saline water purification system in an above-ground
pool with an immediately adjacent natural stone patio/decking, a qualified stone installation specialist
should be consulted regarding the appropriate type, installation, sealant (if any) and maintenance of
stone used around a saline pool with an electronic chlorine generator in your particular location and
circumstances.
NOTE: The use of dry acid (sodium bisulfate) to adjust pool pH is discouraged especially in arid
regions where pool water is subject to excessive evaporation and is not commonly diluted with fresh
water. Dry acid can cause a buildup of by-products that can damage your chlorinator cell.
1
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS