Leuze BPS 8 S M 100 Serie Mode D'emploi page 26

EN
Service operating mode
6
Ä Move SRV bar code within the scanning beam when applying the supply volt-
age.
ð
When in Service mode, the status LED flashes orange.
NOTICE
In Service mode it is possible to access the BPS 8 via the BPS Config-
uration Tool software.
Decommissioning, maintenance
CAUTION
Ä
Do not open the device yourself under any circumstances! There
is otherwise a risk of uncontrolled emission of laser radiation from
the device.
The housing of the BPS 8 does not contain any parts that need to
be adjusted or serviced by the user.
If faults cannot be cleared, the device should be switched off and
protected against accidental use.
Ä
Package the device for transport and storage in such a way that is
protected against shock and humidity. Optimum protection is
achieved when using the original packaging.
Ä
Ensure compliance with the approved environmental conditions
listed in the specifications.
Ä
Do not use aggressive cleaning agents such as thinner or acetone
for cleaning the device.
26