Installation Instructions; Cleaning Instructions - Drive Medical 12013 Mode D'emploi

installation instructions

Weight capacity: 300 lbs (136 Kg)
1. Remove product from carton and READ ALL
INSTRUCTIONS CAREFULLY before
attempting to install product.
2. Lift toilet seat assembly and place rear wings
of toilet seat around rim of toilet bowl. (Some
toilet bowls may require that seat assembly be
removed to allow proper fit.) In addition the
front adjustment bracket must clear the rim in
order for the raised toilet seat to fit securely.
3. With raised toilet seat resting correctly on rim,
straighten and center product over toilet bowl
as necessary. Turn adjusting knob clockwise
to tighten product securely in place. Hand
tighten only - use no tools, and be careful not
to over-tighten, as threads on adjustment
bracket might strip.
4. Check for secure fit routinely before using
product. User's weight should be centered
over toilet seat, not too forward or too far to
one side, as unit may tip.
5. If you have a style of commode that this
product will not fit properly, or cannot be
tightened securely as noted above, it is
recommended that you discontinue usage.
removal instructions
1. Rotate adjusting knob counter clockwise until
seat is loose.
2. Lift front of raised toilet seat and pull forward
to move.
Rev.2.02.28.14

cleaning instructions

1. Use a non-abrasive mild detergent or house
hold cleaner with warm water.
2. Rinse with warm water and wipe dry.
3. DO NOT USE AN ABRASIVE CLEANER OR
CLOTH with this product, as damage may ensue.
caution
1. Always be sure that the seat is correctly and
securely locked in place before using.
2. Be sure that the adjustment knob in front of
the seat is tight at all times, thus securing the
seat to the toilet bowl.
3. Physically challenged users should be
supervised or assisted whenever using this
product.
4. This product is designed for use with the most
common types of commodes. It will not fit all
commode types; be sure that the unit is
correctly installed, fits properly and is stable
before use.
5. On models with arm rests: The arms are for
the purpose of providing assistance when
getting on and off the seat. DO NOT try to
use the arms to support full body weight during
transfer, as this may result in failure of the unit.