Before Use; Parts And Accessories - Braun MultiQuick 9 MQ 9097x Instructions

English
Our products are engineered to meet the highest
standards of quality, functionality and design. We
hope you thoroughly enjoy your new Braun
appliance.

Before use

Please read instructions carefully and
completely before using the appliance.

Parts and Accessories

1 Pilot light
2 Safety button
3 Smart Speed switch / variable speeds
4 Motor part
5 EasyClick Plus Release buttons
6 ActiveBlade shaft
7 Beaker
8 Whisk accessory
a Gearbox
b Whisk
9 Puree accessory
a Gearbox
b Puree shaft
c Paddle
10 1.5-cup / 350 ml chopper accessory «hc»
a Lid
b Chopping blade
c Chopper bowl
d Anti-slip rubber ring
11 5-cup / 1250 ml chopper accessory «bc»
a Lid (with gear)
b Chopping blade
c Ice blade
d Chopper bowl
e Anti-slip rubber ring
12 6-cup / 1500 ml food processor accessory «fp»
a Lid (with gear)
b Coupling for motor part
c Pusher
d Feed tube
e Lid latch
f Food processor bowl
g Anti-slip rubber ring
h Chopping blade
i Insert holder
(i) Slicing insert (fine, coarse)
(ii) Shredding inserts (fine, coarse)
(iii) Julienne insert
j French fry disc
Clean all parts before using for the first time
– refer to «Care and Cleaning».
5722112674_MQ9097X_USCA_S6-28.indd 9 5722112674_MQ9097X_USCA_S6-28.indd 9
Pilot Light
The pilot light (1) shows the status of the appliance,
when it is connected to an electrical outlet.
Pilot light Appliance / Operating status
Flashing red Appliance is ready for use.
Solid green Appliance is released (switch re-
lease button is pressed) and can
be switched on.
Solid Red Early warning about overheating.
Motor slows down, step by step,
till shut off. Let the cool down. It
is ready for use again when the
pilot light fl ashes red.
If the maximum speed decreases under high load
and long running time you can still finish your
preparation, however you should let the appliance
cool down afterwards.
How to Use the Appliance
Smart Speed Switch for
Variable Speeds
One squeeze, all speeds. The more you press, the
higher the speed. The higher the speed, the faster
and finer the blending and chopping results.
One handed operation: the Smart Speed switch (3)
allows you to turn on the appliance and control the
speed with one hand.
Operating your Hand Blender
First use: Remove the transportation lock from the
motor part (4) by pulling it at the red strap.
Switching On (A)
The appliance comes equipped with a safety button
for releasing the Smart Speed switch. To safely turn
it on, follow these points:
• Press the safety button (2) with your thumb. The
Pilot Light will turn solid green.
• Immediately press the Smart Speed switch and
adjust to the desired speed. Note: If the Smart
Speed switch is not pressed within 2 seconds,
the appliance cannot be switched on for safety
reasons. The pilot light will flash red. To switch
the appliance on, start again with first step.
• During operation you do not need to keep the
safety button pressed.
ActiveBlade Shaft (B)
The hand blender is equipped with an ActiveBlade
shaft, which enables the knife extend to the bottom
9
06.06.17 10:21 06.06.17 10:21