Brizo 60 Serie Guide D'utilisation page 8

60 Series Installation
Siderna™ Valve Trim Installation
3
A.
3
1
Slide trim sleeve (1) over cartridge and bonnet
nut (2). When the sleeve is properly positioned
tighten the 2 set screws (3) to secure.
C.
Place the center hole of the escutcheon (1) over
the trim sleeve and carefully push it back to the
mounting plates (2). Magnets on the back of the
escutcheon will keep it in place.
2
3
2
2
1
B.
2
3
Assemble the two mounting sleeves (1) and two
mounting plates (2). Slide the mounting plate
assemblies over the sides of the trim sleeve
as shown. Thread screws (3) into mounting plates
just enough to assemble the 2 sides together.
Slide the mounting plates back against the wall
and finish tightening the screws (3).
D.
2
1
4
Place volume conrol handle (1) over valve stem
(2) and onto the trim sleeve (3). Secure handle
with set screw (4).
6
1
3
1
2
3