Appliance Installation - Caple SD1356SS Manuel D'instruction

7 APPLIANCE INSTALLATION

7.1 Before you begin installation
Open the drawer and remove all accessories and
packing materials.
Attention! The front of the drawer may be covered
with a protective coating over it. Carefully remove the
protection before using the object-holder drawer, starting
to detach it from below. Make sure that the drawer is not
damaged. Be certain that the drawer closes properly. In
case of damage, contact the Service Department.
The object-holder drawer can only be built-in on
appliances specified by
manufacturer does not guarantee the operation of the
appliance if materials from a different manufacturer
have been used. The manufacturer is not responsible
for damage caused by improper use.
7.2 Proceed
Before installing the object-holder drawer and the
appliance combined with it, provide a fixed intermediate
shelf in the cabinet with the capacity to support both
appliances.
The combined appliance is then positioned without
further intermediate shelves directly on the built-in
object-holder drawer.
For the combined, built-in appliance, absolutely follow
the instructions for use and assembly.
The main dimensions for the built-in appliance are
indicated in mm and shown on the installation
diagram. For installation proceed as follows:
1. place the drawer of the cabinet so that it is well
centred and aligned;
2. make sure that the frame perfectly adheres to the
cabinet;
3. open the drawer and fasten the housing to the walls of
the cabinet with the two screws provided.
the manufacturer. The
19
GB