Sensitivity Adjustment; Preparation - Elkron DC600S Guide Rapide

Sensitivity adjustment

Jumpers JP4 and JP5 can be used to determine the sensitivity required to generate a shock alarm. See the following table:
Tamper protection
The tamper switch protects the device from tampering attempts or attempts remove it from the installation surface.
Test
Whenever the Test button is pressed, the device transmits a signal to the control unit to test the radio range and activates

Test mode for 3 minutes.
In Test mode, the LED lights up whenever an alarm is generated.

Test mode is extended by 3 more minutes if the Test button is pressed again.


Preparation

Step 1: Remove the battery insulation.
Step 2: Enable the learning function on the control unit (see the respective manual for more details).
Step 3: Press the Test button on the device to send a signal to the control unit.
Step 4: If the control unit receives the signal correctly will respond by emitting beeps. Refer to the manual of the control unit
to complete the learning process.
Step 5: After the device has been learnt, set the control unit to "Walk Test" mode, by holding the device in the desired
position and press the Test button to check that it is within the wireless range of the control unit.
Step 6: After having checked the correct position of the device, proceed with the installation.
Installation
1. Open the device by undoing the cover fixing screw.
2. Break the hole pattern on the base.
3. Using the base as a template for the holes, make the holes in the installation surface.
4. Insert the anchor bolts.
5. Screw the base to the anchor bolts using the flat head screws provided.
6. Fix the cover to the base and tighten the cover fixing screw.
7. Fix the magnet with screws or double-sided adhesive tape.
Hereby, URMET S.p.A. declares that the radio equipment type: WHITE OR BROWN MINI MAGNETIC CONTACT WITH SHOCK
DETECTOR DC600S and DC600S/BR is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity
is available at the following internet address: www.elkron.com.
CLICK ON THE FOLLOWING LINK OF THE ELKRON SITE TO ACCESS THE PRODUCT TECHNICAL SHEET AND
DOWNLOAD THE COMPLETE MANUAL:
DIRECTIVE 2012/19/EU OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 4 July 2012 on waste electrical and
electronic equipment (WEEE).
The symbol of the crossed-out wheeled bin on the product or on its packaging indicates that this product must not be
disposed of with your other household waste.
Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point
for the recycling of waste electrical and electronic equipment. The separate collection and recycling of your waste
equipment at the time of disposal will help to conserve natural resources and ensure that it is recycled in a manner that protects
human health and the environment.
For more information about where you can drop off your waste equipment for recycling, please contact your local city office,
your household waste disposal service or the shop where you purchased the product.
JP4 JP5
ON OFF
OFF ON
ON ON
SIMPLIFIED EU DECLARATION OF CONFORMITY
ELKRON
Tel. +39 011.3986711 - Fax +39
011.3986703
www.elkron.com – mail to: info@elkron.it
Sensitivity
Low
Medium (default)
High
ELKRON is a trademark of URMET S.p.A.
Via Bologna 188/C – 10154 Turin (TO) Italy
www.urmet.com
MADE IN TAIWAN