Led Indicator - Elkron DC600S Guide Rapide

ENGLISH
WHITE OR BROWN MINI MAGNETIC CONTACT WITH SHOCK DETECTOR
JP3 JP4 JP5 JP2 JP1

LED indicator

In normal operating mode, the LED is off, except for the following situations:
When the tamper switch of the device is opened

When the battery of the device is flat

When the device is in Test mode

The LED does not flash if the tamper switch and the battery of the device are working normally and not in Test mode.
The LED flashes to indicate that a signal is being transmitted and flashes rapidly twice when it receives a recognition signal from
the control unit.
Jumper
Management of alarms generated by opening of the magnet
The detection of the alarm generated by the opening of the magnet can be enabled or disabled by jumper JP1:
 If the jumper is ON (the jumper is inserted on the two pins), detection is deactivated and the shock alarm remain
enabled.
 If the jumper is OFF (jumper removed or "arranged" on a pin), detection is enabled (default setting).
Important note: insert the jumper on JP1 in case you are using the device as shock detector only.
Choice of the type of surface to be protected
Using the jumpers JP2 and JP3 it is possible to choose the type of material of which the surface to be protected is composed.
Refer to the following table:
QUICK GUIDE
DC600S - DC600S/BR
1. LED Indicator/Learning/Test Button
2. Cover fixing screw
3. Wall-mounting hole arrangement
4. Tamper switch
5. Battery insulation
6. Jumper for selecting the type of surface to be protected
(JP2, JP3)
7. Jumper for selecting detection sensitivity (JP4, JP5)
8. Jumper for selecting magnet use mode (JP1)
9. Battery
10. Magnet
11. Magnet fixing screw hole
12. Magnet spacer
Jumper. Default position
JP2 JP3 Surface material
OFF OFF
OFF ON
ON OFF
ON
ON
Wood
Glass
Metal
Concrete
DS80MM1L-002B