Replacing The Battery - Hard Head 019029 Mode D'emploi

REPLACING THE BATTERY

The product runs on 3 batteries.
1. Undo the screws on the battery cover (6) with a
Phillips screwdriver and remove the cover.
2. Insert the batteries in the battery compartment with
the correct polarity.
3. Replace the battery cover and screw tight.
INSTALLATION
The product can be hung up or positioned with the support
leg stuck in the ground.
Support leg
1. Fit the two parts of the aluminium support leg
together (7) and (8). Use a rubber mallet if necessary.
2. Press the support leg firmly in the ground.
3. Hook the fastener (3) underneath the product on the
support leg.
Hanging on wall
The product can be mounted on a wall at the required
height (max 1.2 metres above the ground).
EN
29