Dutch originals DO-CE-WL01-W Manuel D'utilisation page 7

Numérique led lever du soleil
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Powering the device ON/OFF:
• To power ON the device, press the 'power' button
Once powered ON, you will hear a 'tone', the display
shown (initial setting 00:00).
• Power OFF the device: press the 'power' button
'tone' & the display
• When the device is powered OFF, the time can be shown on the display
seconds by pressing one of the buttons
Setting the time:
When powering ON the device, it is in time mode.
By pressing the 'clock' button
minutes.
3
• Use the '-'
or '+'
• Press the 'clock' button
3
5
or '+'
to set the hour. Confirm the set hour by pressing the 'clock' button
• Press the 'clock' button
flashing, and use '-'
pressing the 'clock' button
Note! If there is no activity for ± 3 sec, the time will stop flashing.
Modes
You can select the desired mode. Each mode is described in detail below:
Power ON: time mode => natural sounds => BT => FM =>
If a USB flash drive, Micro SD card and AUX-in are connected, you can select the
desired mode:
Power ON: => time mode => natural sounds => BT => FM => AUX-in => USB Flash
=> Micro SD =>
Note! When a USB flash drive and Micro SD card are connected, these can be
selected, but are indicated with the 'TF' icon on the display
Natural sounds:
When the device is powered ON, press the 'mode' button
sounds. On the display
J
button
to select one of the 7 sounds.
Natural sounds: singing birds 1 => jungle 2 => valley 3 => wind 4 => water creek 5
=> rain 6 => beep 7
Wireless BT
When the device is powered ON, press the 'mode' button
BT mode.
This allows you to connect your smartphone or tablet in order to stream music or
answer phone calls handsfree. You will hear a 'tone' and 'BT' will flash quickly on the
9
will switch OFF.
1
you can switch between setting the hour and
5
buttons to set the time.
1
until the hours on the display
2
two times until the minutes on the display
3
5
or '+'
to set the minutes. Confirm the set minutes by
1
.
9
the 'NS' icon will light up. Press the 'next'
G
for ± 3 seconds.
9
will light up and the time is
G
for ± 3 seconds, you will hear a
1
8
to
.
EN 05
9
9
start flashing, and use '-'
9
start
9
.
G
to listen to natural
H
or 'previous'
G
two times to enable the
for ± 5
1
.

Publicité

Table des Matières
loading

Table des Matières