Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7
Remove the
Juice Pitcher
under the spout. You may close
the
Juice Pitcher Lid
juice in the
Juice Pitcher
desired.
NOTE:
To do this, you'll first
need to tip the
Juice Pitcher
forward at a slight angle,
so that the lid's large hole
has some separation from
the spout, then you can slide
out the pitcher. This is the
reverse of what you did during
assembly.
8
Immediately move the
Spout
cover downward over
the spout to avoid any residual
drips onto the unit or onto the
surface below the juicer.
TIP:
We recommend using your left hand to pull the
Juice Pitcher
away, while using your right hand to
swing the
No-Drip Spout
cover down and over the
spout opening.
Control dial.
DUAL-SPEED CONTROL DIAL
& JUICING SETTINGS
OFF
OFF:
LOW
Power is OFF, the juicer is
not running.
HIGH
OFF
LOW:
LOW
Best for juicing softer fruits
HIGH
and vegetables.
OFF
LOW
HIGH:
Best for harder produce like
HIGH
carrots and beets.
8
Proper produce prep
from
and store
Prepare fruit and veggies before inserting them
if
into the juicer:
• Properly clean produce (rinse with produce wash,
or lukewarm water and apple cider vinegar).
• Peel or remove skin as needed, and chop food
items down to the right size – just small enough
to fit easily into the feed chute, without having to
Food
force the pieces down with the
• Remove rind from all citrus fruits before juicing.
• Remove large pits and seeds from stone fruits
before juicing.
No-Drip
Feed chute
• Never place your hand or fingers into the feed chute
when it is attached to the juicer.
• Always start the juicer before adding food to the
feed chute. The unit must be running when items
enter it.
• Do not overload the feed chute. Items must be
added gradually, at a pace the juicer can keep up
with.
Food Pusher
• Use only the provided
into the feed chute. Never use fingers, utensils, or any
other apparatus.
• Never use excessive force to push items into the feed
chute.
• When juicing, ensure all produce has moved
through the feed chute and into the
adding more.
• If any food gets stuck in the feed chute, use the
Food Pusher
to move it down the chute and into
the Sieve.
Consuming juice and pulp
Instead of composting or throwing away the pulp
left over after juicing, you can choose to consume
Recipe Guide*
it. See our
for some fun tips on what
to do with the leftover pulp. By using these creative
ideas, you can enjoy pulp in a variety of delicious
(and healthy) ways.
• Whether you prefer sweet or savory, you can use
pulp to create some tasty treats!
• For best taste, consume fresh juice and pulp
within 48 hours of juicing.
*Downloadable @ www.nutriliving.shop
No-go foods
Foods that should NEVER be used in this juicer:
• Thicker foods that do not contain juice to extract
(for example, bananas or avocados).
• Frozen fruits or vegetables.
• Stone fruits that have large pits or seeds that
have not been removed. Stone fruits may be
used only if the seed or pit has been removed.
Pusher.
Overheating
• If the motor overheats, the juicer will turn off.
• If the juicer stops working, unplug it and allow it
to cool down for at least fifteen minutes before
attempting to use again.
Disassembly.
1
Ensure the unit is powered
down, turned "OFF," and
unplugged.
to push food
2
Remove the pitcher from under
the spout. To prevent drips use
the
the juice spout.
Sieve
before
3
Unlock the
the
handle backward out of the
"ears" on either side of the
Cover. Move the handle down.
4
Remove the
the Motor Base by pulling
upwards with the
and
take it directly to your sink.
5
Remove the
lifting it out of the feed chute.
6
Lift the Basin Cover vertically
off of the Pulp Basin and
remove any pulp from the
inside of the cover. You may
use the flat end of the
Brush
cover.
Care instructions.
1
Always ensure the
before you begin assembly, disassembly,
cleaning or storage of the unit.
2
Pulp Basin
Once the
under running water.
3
Cleaning Brush
Use the
under running water. Be sure to properly clean
the
Sieve
every time you juice, as minerals
from fruits and vegetables can cause build-
up in the
Sieve
juice extraction.
WARNING:
Always use precaution when cleaning
the Sieve, as it contains sharp blade teeth on the
No-Drip Spout
cover to close
flat disc part.
TIP:
Always clean the
after juicing using the
allowed to sit, pulp will dry on the
Locking Handle
from
it will become more difficult to scrub blocked
Basin Cover
by pulling the
holes. If this happens, be sure to allow the
to soak in hot water for 30 minutes.
Basin
4
All Juicer Pro components except the
Pusher
and
You may also hand wash with warm soapy
Pulp Basin
from
water.
Basin Cover
TIP:
Do not use the Sterilize cycle on your
dishwasher to clean your juicer as it may cause
Sieve
still in place, and
parts to deform.
5
Wipe down
cloth.
Food Pusher
by
WARNING: Never submerge
water or other liquid.
Cleaning
to scrape pulp off of the
7
Gently lift the
Sieve
vertically
out of the center of the Pulp
Basin. Clean the
Sieve
right
away (see care instructions).
8
Pulp
Basin. Use the
Empty the
flat end of the
Cleaning Brush
to
easily scrape out the pulp and set
it aside for use in other recipes or
composting. Or empty the pulp
into your waste bin or compost.
Motor Base
is unplugged
is emptied, rinse all parts
Sieve
to scrub the
which may prohibit maximum
Sieve
as soon as possible
Cleaning
Brush. If
Sieve
and
Sieve
Food
Motor Base
are dishwasher safe.
Motor Base
with a clean, damp
Motor Base
into
9
Publicité
Table des Matières
