NUTRIBULLET NBJ50100 Manuel D'utilisation page 4

Juicing tips.
Juicing speed selection guide
INGREDIENTS SPEEDS
Apple High
Beets High
Blueberry High
Broccoli High
Brussels Sprouts High
Cabbage Low
Carrots High
Cauliflower High
Celery
High
Cucumber
Low
Fennel
High
Ginger High
Grapes Low
Grapefruit Low
Kale High
Kiwi Low
Lemon Low
Lime Low
Melons (all) Low
Orange High
Peaches Low
Pears High
Pineapple High
Plums High
Raspberries Low
Spinach Low
Sweet Potato (raw) High
Tomatoes Low
6
VITAMINS / NUTRIENTS
source of quercetin
excellent source of folate
good source of vitamin C
high in vitamin C, high in folate, good source of potassium
high in vitamin C, good source of folate
high in vitamin C
excellent source of vitamin A, good source of vitamin C
high in vitamin C, good source of folate
good source of vitamin C, good source of vitamin A
good source of vitamin C
good source of vitamin C and potassium
contains vitamin C, magnesium, and potassium
good source of vitamin K
high in vitamin A, high in vitamin C
excellent source of vitamin A and vitamin C, good source of
calcium and potassium
high in vitamin C, good source of potassium and vitamin E
high in vitamin C
high in vitamin C
high in vitamin A, high in vitamin C
high in vitamin C
good source of vitamin C
good source of vitamin C
high in vitamin C
good source of vitamin C
high in vitamin C
high in vitamin A, vitamin C, iron, and folate, good source of
magnesium
good source of potassium, high in vitamin A and vitamin C
high in vitamin A, high in vitamin C, good source of potassium
Assembly & use.
1 Place the Motor Base on a
dry, level counter top Ensure
the dial is set to the "OFF"
position and the unit is
unplugged.
2 Place the Pulp Basin on top of
the Motor Base. Align the Pulp
Basin
with the Motor Base so
that the spout is aligned with
the dimpled side of the Motor
Base.
3 Align the Sieve with the motor
drive coupling and push down
until it clicks into place. Handle
the Sieve by gripping the top
edges being careful not touch
the sharp teeth on the base of
the Sieve. Ensure the Sieve is
properly seated in place and
securely inside of the Pulp
Basin.
4 Place the Basin Cover over
the Sieve and Pulp Basin. The
side "ears" on the Basin Cover
should align with the "ears" on
the sides of the Pulp Basin.
5 Raise the Locking Handle and
move it into the "ears" on each
side of the Basin Cover. The
Locking Handle should be in a
vertical position and locked into
place.
NOTE: if the Locking Handle is
not securely in place, the juicer
will not power on.
6 No-Drip Spout
Swing the
cover up vertically so that it is
no longer covering the juice
spout.
7 Place the Juice Pitcher Lid on top
of the Juice Pitcher, and open the
locking lid latch.
8 Slightly angle the Juice Pitcher
and place it under the juice
spout. Align the spout with the
hole in the Juice Pitcher Lid
and level out the Juice Pitcher.
It will fit snuggly into the spout
to hold it in place.
Usage instructions.
1 Gather all of your desired
ingredients. Wash and prepare
them. Prepare the ingredients
to be juiced by cutting,
skinning, or removing the rind,
stems, or stone seeds.
2
After the juicer is fully
assembled, plug the power
cord into an outlet. Use the
Dual-Speed Control Dial to
select a speed to begin juicing.
You can toggle between
speeds as desired depending
on the type of produce. (Refer
to the chart on the previous
page for recommended speeds
for different types of produce).
3 While the motor is running,
begin gently guiding your
ingredients into the feed chute
using the Food Pusher.
NOTE: Do not use excess force or speed when
pushing food down with the Food Pusher, as it will
not allow for maximum juice yield.
WARNING: Never use hands/fingers or other tools
to push food down the feed chute into the Sieve.
Only the Food Pusher should be used to push down
ingredients.
4 Juice will begin to flow out of
the spout and into the Juice
Pitcher, while the pulp will be
separated and stored in the
Pulp Basin.
5 When the Pulp Basin is
completely full, it must be
emptied before you continue
juicing. See disassembly
instructions.
6 Always be sure to turn the
Dual-Speed Control Dial to the
"OFF" position and wait for the
Sieve
to stop spinning before
removing the Juice Pitcher
from under the spout. Unplug
the unit after each use.
7