Environmental Protection - Raider RD-SA26 Mode D'emploi Original

• Do not use worn, torn or heavily soiled
sheets sanding.
• Wear protective gloves, safety goggles, ear
protectors, adherent body clothing and take
precautions for your hair (if long hair)
• When using sanding machines located over
the head of the operator are subject goggles.
• Before making any adjustment or change of
identity has always unplug the power supply.
• During the use of sander should not have
excessive pressure on it, which could lead to her
suspension
USE
Placing the sanding sheet
• Disconnect the plug.
Dust capture requires the use of perforated
sheets sanding.
Loosen clamps (4) for the attachment of the
sanding sheet.
Place the sheet on the bed sanding (5) of the
sander.
Make sure that open (6) in desktop and
sanding sheet coincide.
Fold both ends of the sanding sheet edges on
the bottom of the sander and press with clamps
(4) for attachment of the sanding sheet.
Make sure sanding sheet is well attached.
• Replace worn sanding time sheets
• Use the machine with all the sanding surface
and always fully covered with a sanding sheet.
DUST CAPTURING
• When using a vacuum cleaner, use the exit
nozzle (3) of sander and join the exhaust system.
Do not use vacuum cleaner when sanding
metal.
• Inclusion / exclusion
Voltage network must correspond to the
value of the voltage on the plate for the technical
details of sanding machines.
Inclusion - press trigger button (1) and stick it
in that position.
Exclusion - trigger release button (1).
Trigger lock button (at constant work)
Include:
Press trigger button (1) and stick it in that
position.
Click on a trigger lock button (2).
Trigger release button (1).
Handset must be switched to reach maximum
speed before touching the work surface.
Include sander having a moderate pressure
and move it to the material being processed.
Dapvo sander and very finely polipane, move
apapata ppavi with movements in the direction
of annual lines.
- Move the camera parallel to the work surface
- Do not exercise pressure on a particular
device, let alone sanding surface to do the job.
By finishing polishing,
pressure, lift the grinding machine over the
surface to be machined, and only then turn off
the grinder engine.
SHUTDOWN:
Press and release the start button (1).
• Keep ventilation holes always clean.
• Never use the same grinding sheet for wood
and metal.
• Abrasive cutting is used with the following
dies: one - to remove paint or to grind a lot
of downy wood;
spade - for grinding of downy and smooth
dough;
fine - for pollinating of dough.
• For more useful instructions, see:
SERVICE AND MAINTENANCE
In case of excessive sparking the collector
should check the status of the carbon brush
motor.
Shorter than 5 mm., Up or broken carbon
brush motor should be replaced immediately.
Always replace both brushes simultaneously.
Operation of
entrusted only to qualified persons using
original parts.
Any kind of failures should be removed from
the authorized service of RAIDER.
Treat carefully to their instruments.

ENVIRONMENTAL PROTECTION

Disposal.
The machine, accessories and packaging
should be sorted for environmental-friendly
recycling. The plastic components are labelled
for categorized recycling. Do not dispose of
power tools into household waste! According
the European Guideline 2012/19/EC for Waste
we reduce
changing carbon
9
the
brushes