Information For Use; Assembly And Operation - Outwell APPETIZER TRIO Mode D'emploi

UK: INSTRUCTION MANUAL

INFORMATION FOR USE

• CAUTION: Accessible parts may be very hot. Keep young children away.
• Never leave the appliance unattended when lit.
• Handle the appliance with care. Make sure not to drop it.
WARNING: Do not move the appliance during use.
• Do not modify the appliance.
• Do not misuse the appliance or use it for other purposes than what it is attended for.
• Do not use metal cooking utensils on the non-stick grill.
• This cooker is designed to accommodate pans between 10 cm and 22 cm (Diam.). Do not
• use smaller or larger pans. Do not use pots or pans on the grill. The grill is to be used for grilling food
only. It is not designed for cooking with pans or pots as this may damage the non-stick coating and/or
cause combustion problems.
• Do not use an appliance which is leaking, damaged or which does not operate properly.
• The appliance shall be operated on a horizontal surface
• non likely to impair its operation
• free from dry grass, sand etc.
• Do not place it on any combustible materials.
• Always disconnect the gas cylinder from the appliance when not in use.
• The appliance shall be used away from flammable materials with minimum distances as shown below
50 cm
50 cm
50 cm
150 cm
50 cm
4
UK: INSTRUCTION MANUAL

ASSEMBLY AND OPERATION

1.
Open the lid by releasing the catches and take out the gas inlet connection and the grill pan. Push both
locking hinges into lock position to secure the lid. The lid can now be used as a wind shield.
Place the grill pan (8) under the non-stick grill.
3.
a. b.
You will need a regulator for 30 & 28-30/37 mbar and a hose (not included). Ask your LPG dealer for advice.
a) If your hose has an internal diameter of 8 mm, push the hose over the first ribbed half of the
removable hose stud. Thread the hose and stud onto the gas inlet connection (4).
b) If your hose has an internal diameter of 10/11 mm, push the hose all the way over the ripped
part of the removable hose stud. Thread the hose and stud onto the gas inlet connection (4).
c) If your hose is equipped with a ¼ " left hand thread, thread the hose directly onto the gas inlet
connection (4).
The hose should be threaded hand tight plus ¼ of a turn.
4.
Ensure that all control knobs are in the off position.
5.
Attach the regulator to a suitable gas cylinder.
6. Check for leaks at all joints using soapy water. NEVER USE A NAKED FLAME TO CHECK FOR LEAKS.
7.
How to light the stove burners (2):
Turn the relevant control knob to maximum
is lit adjust the flame to suit. If the burner does not light after 2-3 attempts turn off the gas.
Hold a lit match or a lighter very close to the burner and slowly open the gas.
8.
How to light the grill burner (3): Hold a lit match or a lighter very close to the burner. Slowly open the gas.
2.
c.
and push the piezo ignition button (7). Once the burner
5