Using Your Ceiling Fan - LUCCI Airfusion Airlie II Eco Serie Guide D'installation

Airfusion Airlie II Installation Instructions
REMOTE CONTROL
Your ceiling fan is controlled via the remote control. There are 4 buttons (HI, MED, LOW, OFF) to control
the fan speed and one button to control light on/off. Fig. 11
Before operating the remote, the following must be considered.
-
2 x AAA 1.5V (size) batteries are required to operate the remote control. Remove the battery
cover from the back of the remote and insert 2 x AAA batteries. Ensure the polarities are correct
as shown in the battery compartment. (Batteries included.)
-
The remote (transmitter) and receiver must be configured so that communication between each
other is paired up. This is achieved by setting the DIP switch on the receiver and remote on the
same setting.
Note: The DIP switch assembly has 4 switches which can be setup to 16 different transmitting
code combinations. This is practical when there is more than 1 remote/receiver pair operating
locally or in the same room.
Note: To access the receiver DIP switches, remove the DIP switch cover.
Fig. 9 Remote battery compartment
9 | P a g e

USING YOUR CEILING FAN

Fig. 8
Fig. 10 Receiver DIP switch