Kalorik VC 42475 Manuel D'instructions page 8

2. Charge on base
• Place the base on a flat, horizontal, stable surface that is not
exposed to direct sunlight or humidity, and far from any heat
source.
• Remove the rubber cover on the base to access the charging pins
on top of the charging station.
• Make sure the appliance is set to off, and all the accessories are
removed.
• Plug the charger into the side of the base, and then plug it into a
wall socket.
• Place the battery into the charging base, making sure that the
connection pins on the base are straight and not crooked. The
battery should insert perfectly into the base
• The LED light on the base lights up red, and will start blinking, to
show that the battery is charging.
• When the battery is fully charged, the LED indicator light should
glow solid red (it will no longer blink).
Note: To remove the battery from the base, simply press the 2 buttons
on each side of the battery and lift it out from its cradle.
Note: We recommend keeping your appliance always in charge when
not in use, this way it will keep a full charge and will always be ready for
use when you need it.
Important: The charger and its cord cannot be repaired. Should they
be damaged, they must be discarded. Contact customer service to
replace them.
www.KALORIK.com
8
VC 42475 - 180228