Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
On the rear wheel, loosen the axle screw with an Allen key (8 mm) and the lock nut with an open-
jaw wrench (size 11).
•
Set the correct chain tension on both sides of the rear wheel by turning the nut of the chain tensi-
oner. You will need an open-jaw wrench (size 10) to do this. It is sufficient to apply slight tension
to the chain. It should not be completely taut, but should still have some play.
•
Turn the rear wheel to ensure that the chain is resting correctly on the sprocket (faster wear and
tear will result if it is not).
•
Tighten the axle screw again.
Over time, the steering rod may become loose, especially if you ride over lots of uneven sur- faces. The
steering rod can be tightened in the following way:
•
Turn the handlebar all the way to the right.
•
Turn the bearing adjusting nut underneath the steering rod anticlockwise a little using an open-jaw
wrench (size 41) or water pump pliers. But do not tighten the adjusting nut too much! The bearing
could be damaged.
•
Remove the saddle post.
•
Open the battery compartment: If it is a plastic footboard, there is a latch under the foot board on
the left side and on the right side. Fold the latches out. Then open up the cover of the battery com-
partment. If it is a aluminum footboard, you can open it directly.
•
Disconnect the battery cable from the cable in the battery compartment. To do this, you must press
the button on the connector. Never pull on the cables! To release a cable connection, only ever pull
on the connector plug.
•
The battery is located in a bag. Pull it up out of the scooter by the carrier handles of the bag.
•
To insert another battery, place the bag containing the battery into the battery compart- ment. Do not
place the battery on the cables in the battery compartment! The cables must be situated to the side
next to the battery so that the cover of the battery compartment can then be closed. We recommend
that you hold the cables in your hand when you insert the battery.
•
Connect the battery cable to the cable in the battery compartment.
•
Close the battery compartment and snap the latches shut. Check whether the latches have closed
correctly.
Retightening the steering rod
Removing and inserting the battery
27
Publicité
Table des Matières
