LABORATOIRE MARQUE VERTE Digitensio PLUS Mode D'emploi page 28

Malfunction
The display remains empty when the instrument is
switched on although the batteries are in place.
The pressure does not rise although the pump
is running.
The device frequently fails to measure the
blood pressure values, or the values measured
are too low (too high).
Every measurement results in different values
although the device functions normally and
the values displayed.
The blood pressure values measured differ from
those measured by the doctor.
Further information
• The level of blood-pressure is subject to fluctuations even in healthy people. It is important to compare
measurements taken under the same conditions and at the same time of day. (Quiet conditions)!
• For licensing, this device has been subjected to strict clinical tests and supervised by experienced
Cardiac Specialists.
• This device is manufactured to meet European standards under the supervision of the
Technical Monitoring Association. (RWTüV-Essen).
• If you have any questions regarding the use of this blood pressure monitor, please ask your dealer or
pharmacist
Never attempt to repair the instrument yourself! Any unauthorized opening of the instrument invalidates all
guarantee claims!
Remedy
1. Check whether the batteries are installed
with the correct polarity and correct if necessary.
2. If the display is unusual, remove the batteries
and then exchange them for new.
• Check the connection of the cuff tube and
connect properly if necessary.
1. Fit the cuff correctly on the arm.
2. Before starting the measurement make sure that
the cuff is not fitted too tightly and that there is
no rolled-up sleeve exerting pressure on the arm
above the measuring position. Take off articles
of clothing if necessary.
3. Measure the blood pressure again in complete
peace and quiet.
• Please read the following information and
the points listed under «Common sources
of error». Repeat the measurement.
• Record the daily development of the values
and consult your doctor about them.
25