Technical Data - Heitronic 37501 Instructions D'installation Et De Service

H. Vollmer GmbH
4. Before Installation/Commissioning

The power distributor may only be operated once removed from the packaging.

Remove the product from the packaging carefully.

Make sure that the connection levels for your building's installation corresponds with the data on the
product type plate.

Make sure that the power distributor has not been damaged during transport before taking it into
operation. The product may not be operated if there are any damages to electrical parts. Repairs may
only be carried out by a qualified electrician.

Keep packaging materials away from children and pets. Danger of suffocation!
5. Installation/Commissioning

The connection lines in the building must be disconnected before installation and secured against being
switched back on. For this, trip the corresponding fuse switch in the building installation.

Choose where to attach the product. Make sure that no water can accumulate around the power
distributor's position.

Make sure that the surface is suitable for permanently and reliably taking the weight of the power
distributor. It may only be taken into operation in an upright position!

Make sure that the maximum capacity of the power distributor is not exceeded before connecting a
consumer.

Fix the extension line in the cable duct provided on the base of the power distributor to avoid any
damages.

Pay attention to possible tripping hazards, especially in walking areas, when laying the cable.

The connection is made to the building's power supply by inserting the plug into a socket.

Do not bend the cables; make sure that the cables and plugs are not subject to tension or torsional
forces. Protect all cables and insulation against possible damages.

Check proper connection once again.

Switch the building installation's fuse switch back on.
6. Faulty Function
Connected consumers won't switch on

Consumer defective?

Voltage test

Check the connected lines

Fuse switched on?

7. Technical Data

Article Connection
37501 250V, 50 ~ 60 Hz
37504 250V, 50 ~ 60 Hz
Remote 1 battery type A23,
control 12V
Installation Instructions Art. No. 37501.37504
Power distributor
4 sockets, 5 m supply
cable
4 sockets, 5 m supply
cable
Page 2 of 3
Protection
capacity
Type
Max. 1200W IP 44
Max. 1200W IP 44
IP 20
Heitronic
H. Vollmer GmbH
Allmendring 29
D-75203 Königsbach-Stein
Protecti
on
Class
I
I
III
®
Dated 12.05.2016