Safety Instructions; Proper Use - Heitronic 37501 Instructions D'installation Et De Service

H. Vollmer GmbH
GB Installation and Operating Instructions
Power distributor
Art. No. 37501, 37504
These operating instructions refer exclusively to the above products.
They contain important information for the start-up and handling of the power distributor.
Therefore pay attention to these operating instructions, even if you pass this product on to
third parties
It is important, therefore, that these instructions are archived carefully for referring to information at a
later stage.
1. Introduction
Dear customer, thank you for deciding to purchase our product.
You have acquired a product from Vollmer, which has been built according to the current state of
technology.
The power distributor fulfils the requirements of effective European and national guidelines.
To maintain the condition of the product and to ensure safe operation, you - as the user - must observe the
instructions of this operation manual!

2. Safety Instructions


The guarantee becomes invalid if damage occurs due to the failure of following these operating
instructions!

We do not accept liability for any consequential damage!

Commissioning is strictly prohibited if there are any damages to the product.

Do not allow children to play unsupervised near the power distributor or other electrical devices.

Do not allow the power distributor to come into contact with extreme heat or naked flames.

Do not install the power distributor in the direct vicinity of water such as pools or garden ponds.

The product in its entirety must not be altered or modified. Alterations to the power distributor invalidate
the guarantee.

Switch off the power supply as a precaution in case of longer periods of absence.

Never subject the product to a direct water jet (e.g. from a hose or high pressure cleaner).

The power distributor may never be operated when covered over.

Sockets may not be switched in sequence!

To disconnect voltage when pull the plug.

The type plate must not be removed.

3. Proper Use

The power distributor is designed for use in indoor/outdoor areas.
This product may:

only be operated with a voltage of 230V ~50Hz

only be operated when mounted to a sturdy, level and non-tilting surface

only be operated on normal or non-flammable surfaces

not be subjected to strong mechanical loads or heavy soiling.
When using outdoors, we recommend that the product is protected with a fault-current circuit
breaker. The installation of such a device may be essential in some regions. Please pay attention to
the local installation regulations!
Installation Instructions Art. No. 37501.37504 Page 1 of 3
®
Heitronic
H. Vollmer GmbH
Allmendring 29
D-75203 Königsbach-Stein
Dated 12.05.2016