Safety And General Information; Product Description; Preparation - SFA OMEGA 21030B Manuel Des Consignes D'utilisation Et Des Pièces

Crics hydrauliques pour entretien de véhicule
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SAFETY AND GENERAL INFORMATION

Save these instructions. For your safety, read, understand, and follow the information provided with and on this device before
using. The owner and/or operator shall have an understanding of the device, its operating characteristics and safety operating
instructions before operating the equipment. The owner and/or operator shall be aware that use and repair of this product may
require special skills and knowledge. Instructions and safety information shall be read to and discussed with the operator in the
operator's native language, making sure that the operator comprehends their contents, before use of this equipment is authorized.
If any doubt exists as to the safe and proper use of this device, remove from service immediately.
Inspect before each use. Do not use if abnormal conditions such as cracked welds, damaged, loose or missing parts are noted.
Any equipment that appears damaged in any way, is found to be worn, or operates abnormally shall be removed from service
until repaired. If the equipment has been or is suspected to have been subjected to an abnormal load or shock, immediately
discontinue use until inspected by a factory authorized repair facility (contact distributor or manufacturer for list of authorized
repair facilities). It is recommended that an annual inspection be made by an authorized repair facility. Labels and Operator's
Manuals are available from the manufacturer.

PRODUCT DESCRIPTION

Hydraulic Service Jack is designed to lift, but not support, one end of a vehicle. Immediately after lifting, loads must be supported
by a pair of appropriately rated jack stands.
!
WARNING: Do not use hydraulic jack as stand-alone device. After lifting, immediately support the lifted vehicle with a pair
of appropriately rated jack stands.

PREPARATION

Assembly
1. Assemble the two-piece handle with provided bolt.
2. Insert handle into the handle sleeve. Tighten the bolt on handle sleeve to prevent accidental removal of handle while in use.
WARNING: Do not lift or carry jack by handle. Handle could dislodge and jack fall, resulting in possible injury or property
!
damage.
WARNING
!
• Study, understand, and follow all instructions before
operating this device.
• Do not exceed rated capacity.
• Use only on hard, level surface.
• Lifting device only. Immediately after lifting, support the
vehicle with appropriate means.
• Lift only on areas of the vehicle as specified by the
vehicle manufacturer.
• Do not move or dolly the vehicle while on the jack.
• No alterations shall be made to this product.
• Failure to heed these markings may result in personal
injury and/or property damage.
WARNING
!
To avoid crushing and related injuries:
• Never work on, under or around a load supported only
by hydraulic jack.
• Always use adequately rated jack stands.
• Chock each unlifted tire in both directions.
• Do not use this device to lift, level, lower, support nor
move a house, mobile home, travel trailer, camper or
any building structure.
• Be alert and sober when using this product. Do not
operate under the influence of drugs or alcohol.
2
X

Publicité

Table des Matières
loading

Table des Matières