Wall Mounting - Motorola D800 Serie Mode D'emploi

D811_IFU_EN.fm Page 22 Friday, September 7, 2007 8:01 PM

15. Wall mounting

IMPORTANT
Before you wall-mount your D801, check that you are not
drilling into any hidden wiring.
Before you drill, make sure the power and telephone line cables
will reach the sockets.
1. Use the following templates to mark the drilling locations.
• To wall-mount the base, drill two holes in the wall 3.6cm
apart horizontally using an 8mm drill bit.
22
• To wall-mount the charger, drill two holes in the wall 4cm
apart horizontally using an 8mm drill bit.
2. Insert the wall plugs if necessary, then insert the screws
leaving about 5mm protruding from the wall on which to
hang the phone.
Wall plug Screw
Wall
XXmm
3. Pull the base/charger out of the stand and slot the holes on
the back of the base over the screw heads and gently pull
the base/charger down to make sure it is securely in place.
Wall mounting