Overtank Lamp For Terrariums; Preliminary Operations - Ferplast EXPLORALIGHT Manuel D'utilisation

EXPLORALIGHT: overtank lamp for terrariums

Preliminary Operations

For your safety, please read the instructions below carefully before
performing maintenance operations of any kind.
• Check that the voltage requirements of appliance correspond to
the power supply voltage.
• This product is intended for indoor use.
• Ensure that your home is protected by a differential safety switch
with a tripping current of no more than 30mA.
• Do not connect the product to the power supply before completing
all installation operations.
• Disconnect the electrical appliance from the power supply before
performing maintenance operations of any kind.
• Connect the plug to the power supply, leaving a loop in the cable
below the socket to prevent drops of water from reaching the
power supply (Fig. 1).
• Remember that water and dust protection levels are ensured
only if the lamps have been inserted and the ring nuts have been
perfectly tightened.
• If the power supply cable is damaged, the entire appliance must
be replaced.
• Any extraordinary maintenance must be performed by qualified
personnel.
Features
Brackets
EXPLORALIGHT overtank lamps come with 2 painted metal
brackets (non-toxic moisture-resistant paint) complete with
suction pads for installing the device above the terrarium
(Fig. 2).
Electronic power supply
The electronic power supply, with fluorescent lamps and
parabolic reflector dish, ensures sufficient light in the
terrarium and maximum safety and simplicity of use and
maintenance.
• Energy saving in accordance with the 2000/55 European
Directive on use of appliances with low energy
consumption.
• Increased durability of the lamps.
• More stable light: more similar to sunlight (absence of the
typical flickering of traditional lighting).
• Greater quality of lighting, which remains constant almost
up to the end of lamp life.
• Lower temperatures: the electronic power supply disperses
little heat.
• Increased safety: when the lamp is at the end of its life,
a sophisticated electronic protection system removes
the electrical current and places the appliance in safety
conditions.
• Lighter in weight: electronic power supplies weigh much
less.
6
English
Fig. 1
Important:
• "Qualified personnel" means a qualified technician
registered in the Roll of Installers.
• "Extraordinary maintenance" means any kind
of maintenance not included in the section
"Maintenance".
B
Fig. 2
A
A Metal brackets
B Suction pads
C Anti-reflection plate
D Watertight lamp holder
E
E
D
Reflective sheets
C