Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
19. Make sure there is no loose connection between the AC outlet and the plug, as
this may cause overheating and distortion of the plug. Contact a qualified
electrician to replace the loose or worn outlet.
20. Use of this heater is not recommended for persons with reduced sensitivity to
heat or inability to react to burns. The output of this heater may vary and its
temperature may become intense enough to burn exposed skin.
21. When not in use, always disconnect the heater by turning the power switch to
the OFF position, then unplug the power cord from the outlet.
SAVE THESE INSTRUCTIONS.
ASSEMBLY INSTRUCTIONS
Unpack your heater and find the wheel-holding plate and butterfly nuts between the
fins assemblies .
1. Make sure the heater is unplugged and in the "OFF" position.
2. TURN THE HEATER UPSIDE DOWN.
3. Attach the wheel-holding plates onto the heater as Fig.1 shows . The U plate is
fixed between the last tow fins and the other one is fixed under metal control box,
Fix the castors to the vertical axis of both
the wheel holding plates.
4. Insert the butterfly nuts and tighten them
securely .
5. TURN THE HEATER UPRIGHT.
Your heater is now ready to use .
WARNING: Risk of fire. Do not operate heater without wheel assemblies
attached. Operate heater in upright position only (wheels on bottom,
controls on top). Any other position could create a hazardous situation.
Ensure that the surface beneath the heater is clean and free of any
obstructions. It is not recommended that this heater be placed on
high-pile carpeting or any other surface that impedes the flow of air
underneath the heater.
OPERATION
A
B
C
D
E
3
Roll caster
Wheel-holding
plates ( U Plate )
Fig.1
Butterfly nuts
Vertical axis
Wheel-holding plates
Metal control box
: Temperature decrease
: ON/OFF button
: Temperature increase
: Timer button
: Mode button
Publicité
Table des Matières
