Sanding Cuts And Sandpaper - Clarke American Sanders OBS-18 Manuel De L'utilisateur

Sanding Cuts and Sandpaper

Initial Cut
The purpose of the initial cut is to remove old finish and gross imperfections on the floor surface. Use a
course (20-36 grit) grain abrasive.
Final Cuts
The purpose of a finishing cut is to remove the scratches produced during the initial cut. Use a fine (60-80
grit) grain abrasive.
If the surface remains rough after a finishing cut, it may be necessary to use an even finer grain of abrasive
(80-100grit). Care should be taken in selecting the grit size of the abrasive. A very fine grain will close the
pores on a wood floor making admission of a stain difficult.
If glazing or burning should occur the abrasive has dulled and must be replaced.
Grain
For removing gross imperfections and restoring
20 grit evenness to old flooring. To remove buildup of
paints and varnishes
For the first sanding of new flooring (maple, oak).
36 grit For removing minor imperfections and finishes
from old flooring.
60 grit For clean-up from initial cut 36 grit.
60 grit
screen mesh
80 grit For final sanding of certain hardwoods. For
80 grit clean-up of cuts (60 grit).
screen mesh
100 grit For final sanding of certain hardwoods and
100 grit conifers where a smooth surface is desired.
screen mesh
120 grit For final sanding of certain hardwoods and
screen mesh conifers where a smooth surface is desired.
For leveling after initial finish coat.
150 grit For scratching surface between coats of finish
screen mesh
180 grit For surface roughing between coats of finish.
screen mesh
Clarke ® American Sanders
Use
Operator's Manual (EN) - OBS-18/18DC
ENGLISH
Standard Professional
Grade Grade
Part #/Qty. Part #/Qty.
945950/10
945951/20
945954/20
945960/20
945955/20
945961/20
945956/20
945962/20
945963/20
945964/20
EN
- 9 -