DigiPower ACTIONPACK RF-6H50 Guide D'utilisation page 10

ENGLISH
IMPORTANT NOTES ABOUT THE ACTIONPACK RF-6H50
• The LEDs on the ActionPack remain on when the
ActionPack is powered on. It will tell you the level of
charge remaining in the ActionPack by the number
of LEDs lit.
• The ActionPack provides power to the camera
battery which then powers the camera. The camera's
battery level will not begin to go down until the
ActionPack battery has been fully depleted.
• With the ActionPack powered on and the camera in
standby or playback modes the battery display on
the camera will show charging.
• With the ActionPack powered on and the camera in
record mode the battery display on the camera will
not show charging but it is still charging, the battery
charge percentage number will remain the same or
slowly increase.
10
• When you are done using the ActionPack power it off
by pressing the power button for 2 seconds. If you do
not press the power button it will continue to provide
power to the internal battery the same way a USB
charger would provide power to your Smartphone.
• Turning on the ActionPack does not turn on the
camera, use the camera's power button to turn it on.
• Turning off the ActionPack does not turn off the
camera, use the camera's power button to turn it off.
• For proper functioning, it is necessary to have the
internal camera battery installed while using the
ActionPack.
• The ActionPack has been tested and approved to IEC
standard IP68 for water and dust ingress. Lab testing
done in a pressurized water tank for 2 hours'
submersion, simulated 33ft/10m depth
ENG