Getting Started; Filling The Water Reservoir - Transcend Heated Humidifier Guide Rapide

GETTING STARTED

Important: It is important to place the Humidifier on a firm, level surface near your bed. It
is recommended that you not place the Humidifier on a surface that could be damaged by
water. The Humidifier should be on a level that is lower than your sleeping position to help
prevent condensation in the mask.

FILLING THE WATER RESERVOIR

1. Remove the Water Reservoir from the
Humidifier by pulling outward (Image a).
2. Remove the Fill Cap (Image b) and
carefully fill the Water Reservoir to the
MAX fill line with distilled water (Image c).
3. Replace the Fill Cap and carefully return
the Water Reservoir to the Humidifier body
(Image d).
STARTING AND ENDING THERAPY
1. Attach the air supply tubing (hose) to the
Humidifier. Be sure your mask is securely
attached to the opposite end of the air
supply tubing (Image e).
Note: Standard 6 foot air tubing is supplied
with the Transcend. If you have been
using the PAP device without the
Humidifier, the universal hose adapter
must be removed from the 6 foot air
tubing prior to use.
2. Place the PAP device into the
corresponding slots at the top of the
Humidifier and slide the PAP device
forward until the nose cone is inside the
humidifier body (Image f).
TRANSCEND HEATED HUMIDIFIER QUICK GUIDE
b
c
d
e
• ENGLISH • PAGE 5