Cleaning And Maintenance - May Way SP - 30 GLS Notice D'installation Et D'emploi

Switching main burner with perpetual flame in stand by position (pictures A,B) (*)
turn the regulation knob of the burner (1) into position „ignition of the helping burner".flame of the main burner
switch off and burn only flame of the helping burner ,which is ready for ignition of the main burner.In case you will
not use the burner for a long time switch off also burning of the helping burner switching in the position „ 0 „
(*) only for burners with perpetual flame – implementation in extra money
Instructions for sucking off the gas products of combustion:
Type A devices (see the label with characteristics). Appliance of finish A, that is the appliance which is not made
for being connected with the chimney or other device for sucking off the products of combustion out of the
space where the appliance is situated. These appliances must be situated in the room with sufficient ventilation
according to the ČSN 12 7010:1986 and ČSN 1207040:1986. It is necessary to prevent the accumulation of the
harmfull matters in big concentration (secure the requestment of hygienic standard for working surrounding sv.
39/78 guideline 46).
Comments and recommendations
use the device only under supervision.

CLEANING AND MAINTENANCE

Clean the device daily. remove stainless grid, you can wash the grid in the dishwasher. stainless parts wash
with moist cleaning cloth and detergent without groove parts then splash it with clean water and dry it by the
cloth.
Advices for cleaning specific parts.
Burners: Remove upper part of the burner and flame devider, put it in warm water to soak out and wash it
carefully, take care, not to get water or dirt inside, because the nozzle could block.
MAINTENANCE
We recommend you to have the device checked once a year by proffesional service. Only qualified or competent
persons can do interventions in the product. It may be necessary to exchange some parts during the useful life
of the device: piezzo electrode, sensor of the thermofuse.
Exchange of the piezzo electrode or thermofuse sensor: picture D
screw up and remove the bottom cover (A), detach and demount the piezzo electrode (b) or the thermofuse
sensor (C). The fitting up of new part must be done in the contrary.
1
regulation knob
1
0
6
switch off
switch on the help
burner (*)
full performance
sporo(lower
performance)