40 electrolux
Replacing the Charcoal Filter
The filter is not washable and cannot be
regenerated. It must be replaced when
led S1 flashes or at least every 4 mon-
ths. The alarm signal will only light up
when the extractor motor is switched
EN
on.
Enabling/Disabling the alarm signal
• In Recirculation version Hoods, the
Filter saturation alarm can be enabled
on installation or at a later date. Turn
the Lights and the suction Motor off.
• Disconnect the Hood using the Main
switch or the double-pole switch on
the mains power supply.
• Restore the connection by pressing
and holding T1.
• Release the button. All five LEDs are
turned on.
• Within 3 seconds press T1 until LEDs
T1 and T4 flash in confirmation:
• 2 flashes – Charcoal Filter saturation
Alarm ENABLED
• 1 flash - Charcoal Filter saturation
Alarm DISABLED
B
Maintenance
A
Alarm signal reset
• Switch off the lights and extractor mo-
tor.
• Press button T3 for at least 3 sec-
onds, until the leds start to flash.
Replacing the Filter
• Remove the metal grease filters
• Remove the saturated activated car-
bon filters as shown (A).
• Fit the new filters (B).
• Replace the metal grease filters.
Light replacement
20 W halogen light.
• Remove the 2 screws fixing the Light-
ing support, and pull it out of from the
Hood.
• Extract the lamp from the Support.
• Replace with another of the same
type, making sure that the two pins
are properly inserted in the lamp hold-
er socket holes.
• Replace the Support, fixing it in place
with the two screws removed as
above..