Remington HAIRCUT TITANIUM X21 Guide D'utilisation Et D'entretien page 7

Selecting Hair Length Setting
The EZ TRIM's adjustable trimmer attach-
ment lets you change trim lengths simply
by rolling the clipper's Zoom Wheel.
Roll the Zoom
Wheel toward
the top of the
clipper to adjust
for longer
length, and
toward the
bottom of the
clipper for
shorter length.
The wheel will
click into one of
9 positions.
Begin trimming
at one of the
longest settings (#8 or #9) to avoid
accidentally trimming hair too short. As
you become familiar with the settings,
you can then select your desired length
setting.
Trimmer Guard Attachment
NOTE: Trimmer guard must be attached to
the clipper in order to use the hair length
selector.
Remove trimmer guard attachment if you
are defining hairline edges such as sideburns,
trimming the nape of your neck, trimming
your beard line on front of neck, or if you
want to clean the cutter assembly.
To remove:
Be sure the
clipper is in the
OFF position.
While holding
clipper in one
hand and hold-
ing the Zoom
Wheel to pre-
vent it from
turning, gently
pull the trimmer
guard attach-
ment away
from the clip-
per. The guard can be removed and
replaced on any setting.
To replace:
Be certain clipper is in OFF position.
While holding the clipper in one hand,
and holding the Zoom Wheel to prevent
it from turning, slide the guard over
the top of the clipper until it clicks
into position.
NOTE: The trimmer guard attachment can
only be placed on the clipper one way; if it
does not fit properly, remove and reverse it.
7