Milwaukee 48-22-8553 Manuel De L'utilisateur page 5

Attaching the Side Handle
Attach the side handle to the station using four bolts
(AA). The side handle can be attached to either side
of the station.
NOTE: The holes in the station are tapped and do
not require nuts.
Installing the Corner Extrusions
and Bumpers
Place the front bumpers on both ends of the extrusion
by sliding the extrusion into the cavity of the bumpers.
Attach the front bumpers with extrusions using two
screws (BB) per bumper.
Attach the two rear bumpers to the back of the lower
cabinet using two screws (BB) per bumper.
Installing the Cord Storage Brackets
Attach the brackets to the station with two screws
(CC) per bracket. Orient the brackets with one
pointed up and one pointed down so that the power
outlet cord can be wrapped around the brackets for
storage.
Attach the tool hanger to the left end of the station
using two bolts (AA).
Attach the shelf hinge brackets to the right cabinet
using two bolts (AA) for each bracket. Attach the
storage shelf to the brackets using one washer (DD),
nut (EE) and bolt (FF) on each end.
AA
Reversing the Wood Work Surface
The wood work surface comes pre-installed with
the station. After wear and tear, the surface may be
reversed to use the clean bottom surface. To reverse,
remove the six screws from the top of the wood work
surface, flip surface, and reinstall the six screws.
Attach the bottle opener to the left side of the cabinet
using two screws (GG).
The USB ports on the power outlet can be used to
charge any device that uses less than 2.1 A of DC
electrical current.
BB
NOTE: Any device that uses more than 2.1 A of DC
electrical current will trip a self-resetting overload and
disable the output.
Place the drawer liners in appropriately sized drawers
to protect the surface.
5
Attaching the Tool Hanger
Installing the Storage Shelf
DD
Installing the Bottle Opener
USB Power Outlet
Installing the Drawer Liners
AA EE
FF