Technaxx HD 720P Mode D'emploi page 3

Operating Instructions
(1a) Battery charging: Use the provided USB cable connect the clock to a computer for
charging, or optional use the DC cable for charging. While charging, the RED light keeps
on lightening and the BLUE light keeps flashing. When the battery is fully charged, the
BLUE light turns off.
(1b) External power supply: The clock has an external "DC socket". The clock supports
5V DC power charging and recording at the same time. Use the provided DC cable.
(2) Power ON: Switch Power button to "ON" position
(3) Lens adjustment: There is a lens adjustment wheel at the back of the clock. Adjust the
camera's angle according to its position and height. Slide the wheel tenderly to avoid
damage.
Sliding up the wheel: The camera watchs more down.
Sliding down the wheel: The camera watchs more up.
Make sure an MicroSD card is plugged in the slot before starting recording!
(4) PIR detection: Press Power button "P" shortly. The YELLOW lights flashs 6 times.
The camera enters to standby status. Once people move into the PIR sensor area,
the camera is triggered and starts video recording.
(5) Manual Recording: Press Power button "P" 2 seconds. The RED light flashs 4 times
and then the BLUE light turns on. Then light turns off and recording starts (it is regular
recording, not PIR recording!). To stop recording and to save the video, press Power button
"P" shortly.
(6) Turn OFF: Press Power button "P" shortly while recording. The camera will stop
recording at once and save the video. Switch the power button to "OFF" position if
camera is not used.
(7) Connecting to a computer: Press Power button "P" to stop the camera working and
then switch the power button to "OFF" position. Using the provided USB cable to
connect the clock to a computer. On the computer screen a "Movable Disk" will pop up
(**). Open it and the recorded video can be watched. If you want to disconnect, go to
the computer's "task bar" on the lower right corner and click the "Movable Device
Management" icon. Then uninstall the removable storage devices. After the message
"safely withdraw" pops up, confirm it. Then the clock can be disconnected from the
computer.
(**) In case you cannot open the "Movable Disk", check if the MicroSD card is plugged
inside.
(**) In case the PC cannot detect the clock's camera, check if USB port on PC maybe is
too loose and/or try another USB port.