Black & Decker HH2455 Mode D'emploi page 7

3. TriMMinG new GrowTH - (figure H) – A wide,
sweeping motion, feeding the blade teeth through the
twigs is most effective. A slight downward tilt of the
blade, in the direction of motion gives the best cutting.
caUTion:
Do not use the trimmer for cutting stems
greater than 3/4 in. (19mm). Use the trimmer only for
cutting normal shrubbery found around houses and
buildings.
4. level HeDGeS (figure i) – To obtain exceptionally
level hedges, a piece of string can be stretched along
the length of the hedge as a guide.
5. SiDe-TriMMinG HeDGeS (figure J) – Begin at the
bottom and sweep up.
warninG:
OBSERVE THE FOLLOWING:
• READ INSTRUCTION MANUAL BEFORE USING,
SAVE INSTRUCTION MANUAL.
• CHECk THE HEDGE FOR FOREIGN OBJECTS SUCH
AS WIRE OR FENCES BEFORE EACH USE.
• KEEP HANDS AWAY FROM BLADES.
• KEEP HANDS ON HANDLES. DON'T OVERREACH.
caUTion:
•
• DO NOT USE UNDER WET CONDITIONS.
• DO NOT USE WITH DAMAGED EXTENSION CORD.
• DO NOT UNPLUG OR STORE WITH SWITCH LOCKED ON.
DanGer:
keeP HanDS away froM blaDeS.
caUTion:
blaDe coaSTS afTer TUrn off.
Problem
• Unit will not start.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACk+DECkER help line at
1-800-544-6986.
TO GUARD AGAINST INJURY,
– BLADE COASTS AFTER TURN OFF.
TroUbleSHooTinG
Possible cause
• Cord not plugged in.
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is damaged.
H
7
i
J
Possible Solution
• Plug tool into a working
outlet.
• Replace circuit fuse.
(If the product repeatedly
causes the circuit fuse to
blow, discontinue use
immediately and have it
serviced at a
BLACk+DECkER
service center or
authorized servicer.)
• Reset circuit breaker.
(If the product repeatedly
causes the circuit
breaker to trip,
discontinue use
immediately and have it
serviced at a
BLACk+DECkER
service center or
authorized servicer.)
• Have cord or switch
replaced at
BLACk+DECkER
Service Center
or Authorized Servicer