Black & Decker HH2455 Mode D'emploi page 6

To lock THe Tool on for conTinUoUS rUn
WITh The TOOl RUNNING, pull the LOCk BUTTON (4) All The WAy back,
release the TRIGGER (5), then release the LOCk BUTTON. The tool is now locked
ON. To turn the tool OFF, squeeze and release the TRIGGER. noTe: In order to lock
the tool on, it is important to first release the trigger and then release the lock button.
roTaTinG THe rear HanDle
The rear handle on the HH2455 has the
capability of rotating 180° while in use.
There are optional stops at 0°, 55° and 90°
which are ideal for side cuts and rounded or
irregular shaped shrubs.
To rotate the rear handle, press in on the
pivoting button (6) and turn in the desired
direction as shown in figure e.
figure f depicts the rear handle in 90° left (f1), 0° (f2) and 90° right (f3) positions.
f
1. exTenSion corD – (figure G) Always keep
extension cord behind trimmer and away from the
trimming operation. Never drape it over a hedge being
trimmed. If you cut or damage the cord, unplug it at
the electrical outlet immediately, before inspecting or
repairing cord.
2. workinG PoSiTion – Maintain proper footing and
balance and do not overreach. Wear safety goggles,
non-skid footwear and rubber gloves when trimming.
Hold the tool firmly in both hands and turn the tool ON.
Always hold the trimmer, as shown in figure G, with
one hand on the switch handle and one hand on the
bail handle. Never hold the tool by the blade guard.
f1
f2
f3
TriMMinG inSTrUcTionS
e
6
6
G