Jackson Maxview Instructions D'assemblage, D'utilisation Et D'entretien page 4

Replacing the Face Shield Headgear
To replace the 370 Faceshield headgear, take the following steps:
1. Remove the Pivot knob on both sides of the headgear.
2. Pull the stud out of the inside of the helmet, then removing all of the Pivot Post,
O-Ring and Pivot Stop on both sides of the helmet.
3. Right side assembly – holding the helmet in front of you, with the back facing you, insert
the threading stud through the headgear strap, Pivot Post, O-Ring and RH Pivot Stop.
Then place this sub assembly into the helmet with the angle adjustment going into the
desired hole. Thread the pivot knob on the stud that is now extending through the helmet.
4. Repeat steps above for the left side of the helmet.
Interchange Welding Helmet System
Helmet Attachment Blades:
• 4-position tilt adjustment allows welder to center the visual field
• Tension knobs allow the welding helmet to be lowered comfortably
• Made from lightweight material that can withstand extreme temperatures of 350°F
• Vertical lock-in eliminates helmet creep securely holding in the upward position
• Approved for use with:
Jackson Slotted front brim hard hats
Interchange Welding Helmet System Instructions
Welding Helmet Attachment and Blades:
1. Hard hat can be worn with the brim forward or backwards. Insert blades into the cap slots
with the button always facing the back of the suspension. (Figure 1)
2. Remove the keeper from the latch with a flat screwdriver. Assemble the attachment
to the welding helmet. (Figure 2/3)
3. Place hard hat on head. Bring welding helmet towards face and insert attachment posts into
the blades. Press firmly on the red knobs inward until a positive click for full engagement.
4. Adjust desired tension with the red knob. Clockwise to tighten. Counter-clockwise to loosen.
Europe:
Balder d.o.o. Teslova ulica 30,
SI-1000 Ljubljana, Slovenia
balder.eu
Figure 1
4
LH Pivot Stop
Base
keeper
latch
knob
button
Figure 2
blade
© Copyright 2020, Surewerx
Pivot Post
O-Ring
RH Pivot
Stop
Pivot
Knob
Stud
Figure 3
Remplacement du har
Pour remplacer le harnais
ci-dessous :
• Enlevez le bouton à pi
côté du harnais.
• Retirez le goujon de l'i
de pivot, le joint toriqu
• Assemblage du côté d
façon à voir l'arrière du
courroie du harnais, p
pivot, le joint torique e
Placez ensuite le harna
d'ajustement d'angle d
sur le goujon qui pass
• Répétez ensuite les ét
JA5446_6/2020