Commissioning/Start-Up - Oase OxyMax 100 Mise En Service

Installing the aerator
 B
• Always install the unit higher than the water level. This prevents water
from possibly flowing back into the pump.
• Use the fastening lug for installation.
• Route the power connection cable such that it forms a drip loop.
During installation, ensure that the unit
• is installed outside of the aquarium,
• is not placed on or over the aquarium,
• cannot fall into the water or move out of position.

Commissioning/start-up

NOTE
Never run the aerator without a hose and air discharge.
Switching on: Connect the unit to the mains. The unit switches on immedi-
ately.
Switching off: Disconnect the unit from the mains.
Adjusting the air quantity and bubble pattern
 C
Air quantity: Adjust the air quantity by turning the air connection control
knob.
Bubble pattern: Take the aerator out of the water and adjust the bubble
pattern at the aerator using a coin. Adhere to the safety instructions!
14