Important Safeguards - Kalorik Pro 1500 Serie Mode D'emploi

Fax +32 2 359 95 50


IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should
always be followed, including the following:
1. READ ALL INSTRUCTIONS BEFORE USE!
2. Check that the voltage in your home corresponds to that stated
on the appliance.
3. To protect against electrical shock, fire or personal injury, do not
immerse cord, plugs, or the appliance in water or other liquid.
4. Close supervision is necessary when any appliance is used by or
near children. As a rule, this appliance is not intended to be used
by children.
5. Unplug from outlet when not in use, before putting on or taking
off parts, and before cleaning.
6. Do not operate any appliance with a damaged cord or plug or
after the appliance malfunctions or has been damaged in any
manner. Return the appliance to the nearest authorized service
facility for examination, repair, or adjustment.
7. The use of accessory attachments not recommended by the
appliance manufacturer may cause fire, electric shock or injury.
8. Do not use outdoors, household use only.
9. Do not let the cord hang over the edge of a table or counter, or
touch hot surfaces.
10. Do not place on or near a hot gas or electric burner, or in a
heated oven.
11. Never feed food by hand. Always use the food pusher.
12. The use of attachments, including canning jars, not
recommended by the manufacturer may cause a risk of injury to
persons.
13. To disconnect, remove the plug from wall outlet.
14. Do not use the appliance for anything other than intended use.
15. Do not place any of the following materials in the appliance:
paper, cardboard, plastic, and the like.
16. Do not leave unit unattended when in use.
17. Avoid contact with moving parts.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you keep
the good numbering when you turn the pages of the I/B.
Don't change the page numbering. Keep the language
integrity. Print only what is inside the frame.
2
Assembly page 2/36
BL 43310 - 120501