Plan The Installation - NuTone NTM Serie Instructions D'installation

PLAN THE INSTALLATION

The hood should be mounted to the bottom of a standard wall
cabinet. If the hood must be mounted directly to the wall, secure
the hood to wall studs.
The hood is connected to a 110-120 V AC lighting circuit (15
amp) in the circuit breaker or fuse box.
• Ductwork can be installed vertically or horizontally.
• Duct runs should be as short as possible.
• Avoid the use of elbows.
• Use duct tape at all joints.
• Do not use duct smaller than the discharge on the hood.
HORIZONTAL DISCHARGE USING 3
CUTOUT DIMENSIONS
¾"
10¼"
C L
CABINET BOTTOM VIEW
HH0055
VERTICAL DISCHARGE USING 6" ROUND DUCT
CUTOUT DIMENSIONS
CABINET TOP VIEW
1" TYP.
6" DIA.
12"
2"
1 ⁄ " X 10" DUCT
4
WALL
CAP
SUPPLIED
ADAPTER/DAMPER
(INSIDE THE HOOD)
3¼"
12"
2"
LOCATION PREPARATION
1. Use the dimensional drawings below to lay out the range
hood's mounting holes, wiring access and ductwork by
marking the cabinet bottom and drywall where applicable.
2. Make cutouts for wiring and ductwork.
3. Install the ductwork so that it is flush to the range hood's
mounting surface.
4. Run two-conductor wire (with ground) from a power source
to the hood location. Bring approximately 12" of wiring
through wiring hole.
5. Drill four
holes are marked in cabinet bottom.
6. Insert (4) mounting screws, leaving approximately
thread exposed.
ADJUSTABLE
SUPPLIED
ADAPTER
1" TYP.
C L
9½" TYP.
5½"
1" TYP.
VERTICAL DISCHARGE USING 3
CUTOUT DIMENSIONS
CABINET TOP VIEW
1" TYP.
3¼"
12"
2"
-2-
3 ⁄ " diameter pilot holes at points where mounting
3 2
ROOF CAP
ELBOW
WALL CAP
C L 1" TYP.
10¼"
9½" TYP.
2¼"
1" TYP.
1 ⁄ " of
4
1 ⁄ " X 10" DUCT
4
ROOF CAP
EAVES
CAP
ADJUSTABLE
ELBOW
SUPPLIED
ADAPTER
WALL
CAP