Fault Finding; The Paddles Do Not Turn; Liquid Drips From The Distribution Nozzle; The Appliance Overheats - Santos 408.071 Serie Manuel D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

FAULT FINDING

Identify the exact cause of the appliance stoppage

The paddles do not turn:

 Make sure that you have indeed actuated (position 1) the respective switches (8)
 Check the mains power supply and the condition of the power supply lead.

Liquid drips from the distribution nozzle:

 Clean the flexible distribution spout (5) (a solid body is probable stuck inside).
 The flexible spout (5) is a consumable. For hygiene reasons, do not hesitate to
replace it regularly

The appliance overheats:

 Ventilation is required to ensure the proper performance of the appliance
 Make sure that the front and back ventilation vents (10) are not obstructed (leave a
gap of at least 15cm).
 Check that there is no dust on the condenser grid (clean using a soft brush)
o Access to the grid: remove the appliance side panels (9)

The temperature of the juice is too high:

 See previous section
 Depending on the volume of product and the ambient temperature, it is sometimes
necessary to wait several hours before reaching the desired temperature.
 If after stabilisation the temperature is inadequate, then adjust the thermostats (12)
(one per juice container; it is recommended that the same setting is used on all the
thermostats)
o Access to the thermostats: remove the appliance side panels (9)
 For multi-container appliances (2 or 3 containers),
with no liquid is not
o Frost quickly forms on the evaporation cup (4) and the thermostat is quickly
triggered, thus stopping the compressor. The other containers are no longer
cooled.
o Always fill the containers with a minimum of 5 cm of liquid

The appliance runs continually without cooling the juice:

 Have the system checked by a refrigeration engineer
 The refrigerant charge is stated on the appliance identification plate.
 Draining and filling the condensing unit is absolutely prohibited in any place not
equipped to collect such gasses.
 Do not use anything other than R134A
98134 EN 2.2 - 12 2010
408071-72-73 en ma 2010.12
"the appliance
overheats"
recommended.
9 / 15
leaving at least one container
www.santos.fr
9/15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

408.072 serie

Table des Matières