Tv Operation - Hitachi Ultravision C55M6 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TV operation

1
To turn on the TV, press POWER. (POWER indicator on the front of the unit changes blue. It
may take approx.10 seconds for a picture to appear on screen.)
2
Adjust the volume level by pressing VOL (VOLUME) + or – . The volume level will be
indicated on the screen by a volume bar. If the volume increases, the number of bars
also increases. If the volume decreases, the number of bars also decreases.
3
Set the Source option to the appropriate selection (see "Air/Cable selection" on page 23).
4
Press the Direct Channel Selection Buttons (0-9, –) to select the channel.
TO SELECT ANALOG CHANNELS
1-9:
10-99:
100-135:
TO SELECT DIGITAL CHANNELS
Press the first digits, then press the – button followed by the remaining number.
Example: To select channel 15-1, press 1, 5, –, 1, then press SELECT.
• If a channel is selected with only audio content, "Audio Only" will be displayed on the
screen.
• If a channel is selected with a weak digital signal, "No Signal" will be displayed on the
screen.
• To direct tune to a digital channel that is not stored in the channel list enter the first
digits followed by - and press SELECT. For example if you want to select channel 15-2,
press 1, 5, - then press SELECT.
• The same program may be available on either an analog channel or a digital channel.
You may choose to watch either format.
NOTE:
• If a channel with no broadcast is selected, the sound will automatically be muted.
• It may take a few seconds for a digital channel picture to appear on screen after being
selected.
• To direct tune to a digital channel that is not stored in the channel list enter the first digits
followed by - and press SELECT. For example if you want to select channel 15-2, press
1, 5, - then press SELECT.
EN16
Press 1-9 as needed.
Example,to select channel 2,press 2, then press SELECT.
Press the 2 digits in order.
Example, to select channel 12, press 1, 2, then press SELECT.
Press the 3 digits in order.
Example, to select channel 120, press 1, 2, 0, then press SELECT.
VHF/UHF/CABLE CHANNELS
Air
VHF
2-13
UHF
14-69
Cable
VHF
2-13
STD/HRC/IRC
14-36
(A) (W)
37-59
(AA) (WW)
60-85
(AAA) (ZZZ)
86-94
(86) (94)
95-99
(A-5) (A-1)
100-135
(100) (135)
01
(4A)

Publicité

Chapitres

Table des Matières
loading

Table des Matières