Switching The Appliance On - Rowenta Intense Pure Air Connect PU408 Serie Mode D'emploi

SWITCHING THE APPLIANCE ON

Setting the pollution sensors
The appliance is preset to medium sensitivity.
If the air quality indicator remains:
– poor after 2 hours in operation although the air seems to be purified
– excellent for more than 1 hour although the air seems to be polluted
you can adjust the sensor sensitivity as follows:
1. When the air purifier is off, hold down the mode setting button for 3 seconds:
2. Set the sensitivity by briefly pressing the mode setting button:
+ Blue
Low sensitivity
• Select high sensitivity if the air purifier indicates excellent air quality for more than 1 hour although the air
seems to be polluted.
• Select low sensitivity if the air purifier continues to indicate poor air quality even though it has been
operating for more than 2 hours and the air seems sufficiently purified.
3. Press 'Start/Stop' button to validate the sensitivity setting.
OPERATION
Start
Briefly press this button to switch the air purifier on or off.
Mode / filtration speed selection
Auto day
Automatic: In this operating mode, the filtration speed automatically adjusts according to the air
quality detected by the particle sensor and the gas sensor. This mode is recommended for general
use.
Auto Night
The filtration speed of your appliance is adjusted for a whisper quiet air flow during the night. The
light intensity of the appliance is also reduced. If pollution is detected, the filtration speed increases
slightly to purify your air but remains quiet to avoid disturbing your sleep.
Boost mode
The highest speed level of filtration.
Silent mode
The whisper quiet speed.
Light
You can change the light intensity of the appliance as you wish or according to the time of day.
+ Purple
Medium sensitivity
+ Red
High sensitivity
EN
17