Zemi ARIA Guide De Démarrage Rapide page 17

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Compliance
FCC Statement
This equipment has been tested and
found to comply with the limits for
a Class B digital device, pursuant
to Part 15 of the FCC rules. These
limits are designed to provide
reasonable protection against
harmful interference in a residential
installation. This equipment
generates, uses and can radiate
radio frequency energy and, if not
installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and
on, the user is encouraged to try to
correct the interference by one of
the following measures:
-
reorient or relocate
the equipment
-
connect the equipment to an
outlet on a circuit different
from that to which the receiver
is connected
-
consult the dealer or an
experienced radio/TV technician
for help.
FCC Caution
Any changes or modifications not
expressly approved by the party
responsible for compliance could
void the user's authority to operate
the equipment.
This device complies with part 15 of
the FCC Rules. Operation is subject
to the following two conditions: (1)
This device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
This device and its antenna must
NOT be co-located or used in
conjunction with any other antenna
or transmitter. Important note:
Radiation exposure statement.
This EUT is compliant with SAR for
general population / uncontrolled
exposure limits in ANSI/IEEE
C95.1-1999 and has been tested in
accordance with the measurement
methods and procedures specified
in OET bulletin 65 supplement C.
To satisfy FCC / IC RF exposure
requirements, a separation distance
of 20 cm or more should be
maintained between the antenna of
this device and persons during device
operation. To ensure compliance,
operations at closer than this
distance is not recommended.
17

Publicité

Chapitres

Table des Matières
loading

Table des Matières