To Start The Engine - Yardworks 060-1330-4 Guide D'utilisation

14

TO START THE ENGINE

NOTE: Due to protective coatings on the engine, a
small amount of smoke may be present during the
initial use of the lawn mower. This is normal.
NOTE: Your engine may be equipped with an
automatic choke system. No priming or choking is
required before starting for these models. On other
models, either a choke lever or a priming bulb is
provided. Use this to start a cold engine.
TO START THE ENGINE USING STARTER ROPE
1. Turn fuel shut-off valve to ON position (if
equipped). See engine manual for more
information.
2. To start the engine
using the starter rope,
hold the operator
presence control bar
down to the upper
handle.
3. Pull the starter handle
(at the end of the
starter rope) quickly.
DO NOT allow the
starter rope to snap
back.
TO START THE ENGINE USING THE KEY START (IF
EQUIPPED)
1. Turn fuel shut-off
valve to ON position
(if equipped). See
engine manual for
more information.
2. To start the engine,
hold the operator
presence control bar
down to the handle.
3. Turn the start key or
press the start button.
IMPORTANT NOTE: DO NOT CRANK THE ENGINE
CONTINUOUSLY FOR MORE THAN FIVE SECONDS
EACH TIME YOU TRY TO START. WAIT FIVE TO
TEN SECONDS BETWEEN EACH ATTEMPT TO
START.
1
2
1
2
TO STOP THE ENGINE AND BLADE
1. To stop the engine,
release the operator
presence control bar.
2. Turn fuel shut-off
valve to OFF position
(if equipped). See
engine manual for
more information.
TO SET THE MOWER CUTTING HEIGHT
IMPORTANT NOTE: MAKE SURE ENGINE AND
BLADE ARE STOPPED.
Adjust the cutting height to suit your requirements.
The middle position is suitable for most lawns. Raise
the wheels for low cut and lower the wheels for a high
cut. See page 17 of this manual for a grass height
cutting guide.
NOTE: For shipping purposes, the height adjustment
position may not be adjusted to the cutting position.
Before operating the mower, adjust cutting height to
the normal cutting position.
SINGLE POINT HEIGHT ADJUSTMENT
MODELS
All four wheels are
adjusted by a single
lever.
1. Pull height adjuster
toward wheel.
2. To raise the mower,
move the lever
forward to desired
position. To lower
the mower, move the
lever toward the rear.
®
/MD